Estudio preliminar de la copolimerización de acrilamida con el itaconato de mono y dimetoxietilo
Voir/ Ouvrir
Date
2011-10-04Auteur
Palabras Clave
Acrilamida, Itaconato de monometoxietilo, Itaconato de dimetoxietilo, CopolimerizaciónAcrylamide, Monomethoxyethyl itaconate, Dimethoxyethyl itaconate, Copolymerization
Metadatos
Afficher la notice complèteRésumé
En el presente trabajo se describe la copolimerización de la acrilamida (AAm) con el itaconato de monometoxietilo (IME) y el itaconato de dimetoxietilo (IDE) en varias proporciones molares. Las polimerizaciones se llevaron a cabo tanto en masa como en solución utilizando como iniciadores 2,2´- azobisisobutironitrilo (AIBN) y persulfato de amonio, respectivamente. Los copolímeros obtenidos resultaron ser solubles en agua y los mismos fueron analizados mediante espectroscopia FTIR y análisis termogravimétrico (TGA y DTGA). Los copolímeros AAm/IDE se obtuvieron con altos rendimientos y resultaron térmicamente estables hasta los 200°C, mientras que los rendimientos de los AAm/IME, fueron menores y comienzan a perder peso a los 150°C. Finalmente, se prepararon Hidrogeles AAm/IME y AAm/IDE empleando una proporción 80/20 molar y un 1% de entrecruzante. Se estudió la capacidad de hinchamiento de estos materiales encontrándose que en ambos casos ésta es superior a la del hidrogel de AAm pura preparado en las mismas condiciones.
Colecciones
Información Adicional
Correo Electrónico | rojasl@ula.ve flopezc@ula.ve |
ISBN | 1856-3201 |
Resumen en otro Idioma | The copolymerization of acrylamide (AAm) with monomethoxyethyl itaconate (IME) and dimethoxyethyl itaconate (IDE) was studied, using various molar relations AAm/itaconate. The polymerization reactions were carried out both in bulk and in solution, using 2,2´- azobisisobutyronitrile and ammonium persulfate respectively as initiators. The copolymers obtained were soluble in water and these were characterized by means FTIR spectroscopy and Thermogravimetric analysis (TGA and DTGA). The copolymers AAm/IDE were obtained with high yields and they were thermally stable up to 200ºC, whereas the yields of the copolymers AAm/IME were lower and they were stable up to 150ºC. Finally, hydrogels AAm/IME and AAm/IDE were prepared using the molar relation AAm/Itaconate 80/20 with 1% of crosslinking agent. It was found that swelling of these hydrogels was higher than those obtained with AAm in the same experimental conditions. |
Colación | 21-28 |
Periodicidad | cuatrimestre |
Publicación Electrónica | Revista Avances en Química |
Sección | Revista Avances en Química: Artículos Científicos |